- Important information
- New features
- Known problems
- Program corrections
- User documentation corrections
- Miscellaneous
- Release history
Important information
-
To debug using FTDI, the USB driver has to be installed. The driver is
found in the
drivers\LuminaryFTDIdirectory on the installation CD-ROM. In addition, it is available in thearm\drivers\LuminaryFTDIdirectory in the product installation.
If the USB driver is not installed C-SPY will fail to load LMIFTDI driver (ARMLmiFtdi.dll)
New features
- None.
Known problems
- None.
Program corrections
- None.
User documentation corrections
- None.
Miscellaneous
- None.
Release history
V5.40 2009-07-10
New features- Supports both SWD and JTAG.
- None.
V5.30 2009-01-23
New features- None.
-
Data breakpoints could only be used right after first download.
Any subsequent downloads, data breakpoints were disabled and could not be enabled.
[EW20360]
V5.20 2008-06-24
New features- None.
-
For Cortex-M, the hardware breakpoint was not removed when it was cleared.
This happened when there was only one breakpoint set.
[EW20251]
V5.11 2007-11-28
New features-
Data breakpoints. For more information refer to
Part 6. C-SPY hardware debugger systems in the EWARM User Guide
-
For Cortex-M3, sometimes the debugger incorrectly left hardware breakpoints enabled during step which made the target seem to be halted on the current address.
[EW18848]
V5.10 2007-07-02
- Cortex-M3 was not supported in 5.10.
V4.41A 2006-12-08
New features- Derivatives based on Rev C silicon are supported.
- There is USB driver support for both old and new evaluation boards.
V4.40A 2006-07-07
- First release.