QuickStart reference for OKI ROM-monitor

Getting started with the JOB671000 evaluation board

Follow these instructions to use C-SPY with the JOB671000 evaluation board:

Connect the evaluation board to your host computer.
Start the IAR Embedded Workbench and open the job example project found at ...\arm\examples\oki\JOB671000
This project assumes that the board is connected via USB. (To change this, see example 2.)
You can now start the debug session. Choose Project>Debug (or click the C-SPY button on the toolbar) to download the code to the target and start debugging.
Detailed information about the job example file can be found in the readme.txt file at ...\arm\examples\oki\JOB671000

Connect the evaluation board to your host computer.
Start the IAR Embedded Workbench and open the tutor example project.
This project has been preconfigured to use the simulator driver, so to run the application on JOB671000 you must change the driver.
Choose Project>Options and select the C-SPY category.
Change the Driver option to OKI ROM-monitor.
Go to the OKI ROM-monitor page of the C-SPY options and select the connection type you want to use, USB or serial RS232.
USB can be used on Windows 98/ME/2000 etc. and is already selected by default.
If you have Windows NT4, which does not support USB, you must now change to RS232 serial communication, otherwise you will get an error message when the ROM-monitor driver for USB cannot be loaded.

Make sure that you have a linker command file that matches the JOB671000 hardware. To select a linker command file, choose Project>Options and go to the Include page of the XLINK category. A sample linker command file for JOB671000 can be found in the ...\arm\examples\oki\JOB671000 directory.

You can now start the debug session. Choose Project>Debug (or click the C-SPY button on the toolbar) to download the code to the target and start debugging.